LIGO Document P1400255-v2

Enhancing the bandwidth of gravitational-wave detectors with unstable optomechanical filters

Document #:
LIGO-P1400255-v2
Document type:
P - Publications
Other Versions:
Abstract:
For gravitational-wave interferometric detectors, there is a tradeoff between the detector bandwidth and peak sensitivity when focusing on the shot noise level. This has to do with the frequency-dependent propagation phase lag (positive dispersion) of the signal. We consider embedding an active unstable filter—a cavity-assisted optomechanical device operating in the instability regime—inside the interferometer to compensate the phase, and using feedback control to stabilize the entire system. We show that this scheme in principle can enhance the bandwidth without scarifying the peak sensitivity. However, there is one practical difficulty for implementing it due to the thermal fluctuation of the mechanical oscillator in the optomechanical filter, which puts a very stringent requirement on the environmental temperature and the mechanical quality factor.
Files in Document:
Topics:
Notes and Changes:
(1) A systematic way of introducing stabilizing controller using the state-space approach is included.

(2) The control scheme is modified---using heterodyne detection only to measure a small pickoff of the output signal for control purpose, and the rest is measured using homodyne detection. This makes the sensitivity sqrt(2) times better than the previous case that uses heterodyne detection to measure all the output signal (a misunderstanding of the control problem).


DCC Version 3.4.2, contact DCC Help